Research, Innovation & Development (RID)Īncable Replacement 4-Pack TRRS Male Plug 4 Pole 1/8" 3.5mm Solder Type DIY Audio Cable Connector for Repair Headphones Headset Electronics Ancable Replacement 4-Pack TRRS Male Plug 4 Pole 1/8" 3.5mm Solder Type DIY Audio Cable Connector for Repair Headphones Headset Electronics. Innovation and Development Accelerator (IDA). Information & Communication Technology Services (ICT). Corporate Engagement & International Relations (CEIRD). Sam Nujoma Marine & Coastal Resources Research Centre. Quality Assurance and Management (CEQUAM). Centre for Innovation in Learning and Teaching (CILT). Grants Management and Resource Mobilization. Faculty of Health Sciences & Veterinary Medicine. School of Humanities, Society & Development. School of Business Management, Governance & Economics. School of Engineering & the Built Environment. School of Agriculture & Fisheries Sciences. 
Faculty of Agriculture, Engineering & Natural Sciences. Online Support for Distance Education/Part-time Studies. Distance/Part-time Postgraduate Programmes. Distance/Part-time Undergraduate Programmes. Distance Education/Part-time Requirements. Perhaps you have to push it one click further. One last thing: Might sound stupid, but be sure the cable is completely plugged into the splitter. Don’t forget to press “play” for monitoring in sample mode. If you can controll the input sound like in mic-mode: Sampling will also work! Sampling won’t be possible and you have to check your connections. I don’t know the wiring, but that might happen. If nothing happens: the signal you hear is NOT fed through the op-z, but directly to the output. Now try to control volume or try to activate FX1/2 for the mic, as mentioned in the manual. If you hear a dim signal but are not sure if it’s really fed into the OP-Z: BEFORE entering sample mode, pick the OP-Z up, as if you want to use the internal mic. You can’t switch to headset-mode, WHILE in sampling mode! 
I think I first tried a mono cable and it did NOT work (not sure about that, because I had a lot going on on my table But might be worth checking…)Īctivate headset-mode by pressing “screen” and “shift” BEFORE entering sample mode. I use a stereo-cable to connect the kastle to the splitter’s mic-input. And it works like a charm, without any problems.
0 kommentar(er)
